Blog · 
16 October 2026
 · 
6 min read

Is Your Solar Actually Working? 7 Signs Your System Is Underperforming

From error lights to new shade and ageing inverters, here are seven signs your solar is underperforming and what you can safely check yourself.

Solar panels on a Brisbane roof with the city skyline behind

Solar is easy to forget about. The panels sit on the roof, the inverter hums away in the garage, and you assume it is all quietly saving you money.

But solar systems can stop pulling their weight without any obvious warning. A tripped switch, a fault code nobody noticed or a tree that has grown a metre since installation can all cut your output, sometimes to zero.

Here are seven signs your system may be underperforming, what you can safely check yourself, and when it is time to call a licensed electrician.

First, what should your system be producing?

A useful rule of thumb comes from Clean Energy Council guidance: in Brisbane, a solar system produces around 4.2 kWh per day for every kilowatt of panels, averaged across the year.

So as a rough yearly average:

  • A 6.6 kW system: around 27 to 28 kWh a day
  • A 10 kW system: around 42 kWh a day
  • A 13 kW system: around 54 to 55 kWh a day

Expect more on long, clear summer days and less in winter or during a week of storms. Shading, roof direction, tilt and panel age also make a difference, so treat these as a ballpark rather than a target your system must hit every day.

The 7 warning signs

1. Your power bill has crept back up

If nothing has changed at home but your bill is noticeably higher than the same season last year, your solar may be producing less. Compare bills quarter for quarter, as summer and winter are very different.

Keep in mind that tariffs and feed-in rates change too. A higher bill is a prompt to investigate, not proof of a fault.

2. The inverter shows a red or orange light, an error code, or a blank screen

The inverter is the box that converts your solar power into power your home can use. It is the first place to look.

  • Green or normal status: usually all good.
  • Red or orange light, or a fault message: something needs attention.
  • Completely blank on a sunny day: the system may be off or faulty.

Photograph any error code. It helps an electrician diagnose the problem faster.

Solar panels being washed down on a Brisbane roof
Panels can look perfectly fine from the ground while the system produces little or nothing.

3. Your monitoring app shows low or zero generation on sunny days

Most modern inverters come with an app or web portal. Check it on a clear day around midday. If generation is flat, unusually low, or the app shows the system has been offline for days, that is a red flag.

Sometimes the issue is just the Wi-Fi connection dropping out, which stops the data, not the solar. But it is worth confirming, because an offline system can also affect how your inverter manages exports on some connections.

4. New shade from trees, buildings or roof additions

The Clean Energy Council notes that even a small amount of shade can noticeably reduce a panel's output, and shade on one part of a panel can drag down more than just that spot.

Brisbane trees grow fast. A tree that cast no shadow at installation can shade a whole row of panels a few years later.

5. Dirty panels

Brisbane's regular summer storms do a decent job of rinsing panels. But rain does not shift everything. Bird droppings, bat mess, leaf litter, dust from nearby construction and grime on low-tilt panels can all build up.

If your panels look visibly dirty from the ground, mention it to your electrician. Do not climb onto the roof to clean them yourself.

6. A tripped solar switch or safety switch

Storms, power surges and faults can trip the solar circuit breaker in your switchboard. If your inverter is blank and the solar breaker is off, that may be the cause.

You can check whether the breaker is visibly tripped. If it trips again after you reset it once, or there was storm or water damage, leave it off and call an electrician. Repeated tripping usually means a fault that needs finding.

Quick tip: Do not touch the DC isolators near the panels or inverter, and never open up any solar equipment. The cables from the panels to the inverter stay live in daylight, even when the main power is off.

7. Your inverter is getting on in years

Panels are built to last well over 20 years, but inverters are not. Solar Victoria's buyer guide says inverters are not generally expected to last much more than 10 to 15 years, and that you can expect to replace yours at least once over the life of the system.

If your system went in around 2015 or earlier and the inverter is starting to throw errors or switch off on hot days, it may be nearing the end of its life.

What about export limits?

Sometimes the system is working fine, but output is capped. In the Energex network, a standard connection can export up to 5 kW per phase, and less in some constrained areas. Systems on a dynamic connection can export more when the network has room, but drop back to 1.5 kW if their internet connection drops out.

That means you may see generation flatten in the middle of the day while you are not using much power at home. It is not always a fault, but it is a sign your usage and system settings could be better matched, for example by running appliances during the day or adding a battery.

Solar inverter and switchboard installed inside a home
When output drops, the inverter is the first place to look.

What you can safely check, and what to leave alone

Safe for owners to check:

  • The inverter display and status light
  • Your monitoring app or portal
  • Bills, compared season to season
  • Whether the solar breaker in the switchboard looks tripped
  • New shade, viewed from the ground

Leave to a licensed electrician:

  • Anything involving DC isolators, DC wiring or opening equipment
  • Getting on the roof for any reason
  • A system with storm, water or physical damage
  • Breakers that keep tripping

Queensland's Electrical Safety Office is clear on this: never do your own electrical maintenance or repairs, and do not attempt to turn off a system that has water or storm damage. Contact your electrician or installer instead.

Quick tip: Regular servicing helps catch problems early. Our article on why solar servicing matters explains what a routine check covers.

Frequently asked questions

How do I know if my solar is producing enough?

As a rough guide, divide your average daily production by your system size in kW. In Brisbane, a yearly average of around 4.2 kWh per kW is typical. If you are well below that over several sunny weeks, it is worth getting checked.

Can I reset my inverter myself?

Many inverters have a simple restart procedure in the owner's manual, and following it is generally fine if there is no storm or water damage. But if the fault returns, the switch keeps tripping, or there is any damage, stop and call a licensed electrician.

Is it worth repairing an old inverter?

Sometimes. It depends on the fault, the age of the unit and whether parts are available. An electrician can tell you whether a repair or a replacement makes more sense, and whether a battery-ready inverter is worth considering.

Should I clean my panels myself?

We do not recommend it. Roof work is dangerous, and the wrong cleaning method can damage panels. If they need cleaning, have it done as part of a service.

Think your solar is underperforming?

Josh is a licensed electrician who diagnoses solar faults, replaces inverters and services systems across North Brisbane. You deal directly with the person doing the work, and you get a straight answer about whether it is worth fixing. Book your free energy assessment and get your system back to doing its job.

Josh, licensed electrician and owner of Advance Energy
Questions? Talk directly to Josh
Licensed electrician and owner. Honest advice about what suits your home.

Related

Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.
Your enquiry goes straight to Josh, a licensed electrician who designs and installs your system.
By submitting, you agree to Advance Energy contacting you about your quote.
Call Josh · 0474 505 395